Working Instructions; Swivelling The Battery-Powered Led Flood Lamp; Hanging The Battery- Powered Led Flood Lamp; Tripod Mount - Parkside PLSA 20-Li A1 Originalbetriebsanleitung

GB IE

Working instructions

Do not stare into the battery-powe-
red LED flood lamp while it is on.
Swivelling the battery-
powered LED flood lamp
1. Loosen the adjusting screw (4).
2. Rotate the handle (3) of the battery-
powered LED flood lamp to the desired
position.
3. Tighten the adjusting screw (4).
Hanging the battery-
powered LED flood lamp
Hanging the battery-powered
LED flood lamp on the hook
1. Fold the hook (5) outwards.
2. Hang the device horizontally.
Hanging the battery-powered
LED flood lamp using the key-
hole bore
1. Insert a screw or nail at the desired po-
sition on a wall.
2. The screw/nail head can have a dia-
meter of 7 - 10 mm.
3. Leave the screw/nail head protruding
at a distance of approx. 10 mm from
the wall.
4. Hang the device on the keyhole bore
(15).
20
Hanging the battery-powered
LED flood lamp on the base-
plate
1. Insert a screw or nail at the desired po-
sition on a wall.
2. The screw/nail head can have a dia-
meter of 7 - 10 mm.
3. Leave the screw/nail head protruding
at a distance of approx. 10 mm from
the wall.
4. Hang the device via the recess (6) on
the baseplate with teeth. The teeth
allow you to balance the device.

Tripod mount

/ /
Using the 1 " or 5
4
you can screw the battery-powered LED flood
lamp to a tripod (not included in delivery).

Maintenance

The device is maintenance free.

Cleaning

Switch the device off before cleaning
and remove the battery from the
device. Risk of electric shock!
• Clean the device with a soft, dry cloth
to avoid scratching the cover of the LED
lamp.
• Do not use any abrasive cleaning
agents or solvents. This could damage
the device irreparably.
• Do not use water or metallic aids. There
is a risk of a short circuit.
" internal thread (16),
8