Maintenance; Troubleshooting; Cleaning And Care; Disposal - LIVARNO LUX 10278A Bedienungs- Und Sicherheitshinweise

Inbetriebnahme/Gebrauch/Wartung/Fehlerbehebung/Reinigung und Pflege
● Initial use
Note:
the rechargeable battery is always factory
installed.
To achieve a long battery life, fully charge the
❑
rechargeable battery in OFF mode (approx.
3x8 hours in summer).
Then fully discharge the rechargeable battery,
❑
(turn on PIR mode approx. 35 x 90 seconds).
Repeat this process once or twice.
❑
If the product has not been used for more than
❑
6 months please repeat this process
● Use
The light features three settings (see Figure C):
❑
ECO:
Permanent light.
OFF:
Light always off
PIR:
Motion detector controls the light
ECO
In „ " the light switch on at twilight. The
❑
light is on with reduced light intensity. The
light switch off after 8 hours (by full charged
battery).
OFF
In „ " the light is off, but the solar panel is
❑
still charging.
„PIR"
In the light will switch on if the
❑
surroundings are very dimly lit and motion
is detected (infrared sensor). The light will
automatically switch off after 90 seconds if
motion is no longer detected.
Attention:
a light sensor is located inside
the solar panel on top of the light. The panel
must therefore be mounted far away from
artificial light sources.
Note:
when the light is put from the OFF-
position to the PIR-position, it takes 5 seconds
before the PIR setting is activated.
● Maintenance
● Changing the battery
Change the battery according to the
❑
instructions in figure B and C.
GB
8
● Troubleshooting
This product contains delicate electronic
❑
components. This means that if it is placed
near an object that transmits radio signals, it
could cause interference. This could be, for
example, mobile telephones, walkie talkies,
CB radios, remote controls and microwaves. If
interference occurs, move such objects away
from the appliance.
Electrostatic discharges can lead to
❑
malfunctions. In the event of such malfunctions
briefly remove and reinsert the rechargeable
batteries.
● Cleaning and Care
Never use cleaners or a rough cloth. These
■
could dame the motion sensor.
Clean the product with a dry, lint-free cloth.
■
Make sure the solar cell is free of dirt and
■
free of snow and ice in winter. Otherwise the
performance of the solar panel will diminish.
● Disposal
The packaging is made of
environmentally friendly materials,
which may be disposed through your
local recycling facilities.
Do not dispose of used and/ or defective modules
with household waste! Dispose of these items in a
collection centre provided by your local council.
Do not dispose of electrical
equipment in the household
waste!
In accordance with European Directive
2012/19/EC relating to old electrical and
electronic appliances and its translation into
national law, used electrical equipment must be
collected separately and recycled in an
ecologically compatible way.
If you wish to part with the product, please
dispose of it in accordance with the regulations