The Base Station; Fastening The Base Station; Storing After Use; Charging The Battery - Silvercrest SHAZ 21.6 B2 Bedienungsanleitung

5. The base station

5.1 Fastening the base sta-
tion
26
Fasten the base station 26 to the wall using
the drilling template and the fixing material
included in the delivery.
NOTE:
• Before fastening, check that the fixing
material included in the delivery meets
your requirements (e.g. wall structure).
If not, replace it with suitable fixing ma-
terial.
1. Look for a place on the wall for the base
station 26. Make sure that there is a
wall socket nearby.
2. Using the drilling template, draw the
marking for the drill holes on the wall.
3. Drill holes with a diameter of 6 mm us-
ing a drill.
4. Insert the rawlplugs into the drill holes.
5. Tighten the screws in the rawlplugs.
6. Hang the base station 26 up on the
wall and check for a secure hold.

5.2 Storing after use

The base station 26 is used as a holder and
battery charger for the suction device 5 and
the suction pipe 20.
26
5
20

6. Charging the battery

NOTES:
• Fully charge the battery before using it
for the first time. This takes approx.
5 hours.
• After every use, hang the suction de-
vice 5 up in the holder of the base sta-
tion 26. This ensures that the suction
device will always work at full power.
The battery is not damaged by regular
charging.
Charging the suction device via the
base station
32 31
The wall socket must continue to be easily
accessible after the device is plugged in.
• After every use, hang
the suction device 5
and the suction
pipe 20 up in the
base station 26. The
battery is charged au-
tomatically.
• The large nozzle 38
and the large brush
nozzle 37 can be
plugged onto the
holders 30.
1. Plug the power
adapter 31 into a
suitable wall socket
and connect the
power cable with
the connection for
the power adapt-
er 32.
GB
7