Proservo NMS83
Gauge command 3
Navigation
Voraussetzung
Beschreibung
Auswahl
Werkseinstellung
Zusätzliche Information
Endress+Hauser
Setup → Erweitertes Setup → Ein/Ausgang → Digitaleingang Belegung → Gauge
command 3
• Quelle Digitaleingang 1 (→ 226) ≠ Keine
• Quelle Digitaleingang 2 (→ 226) ≠ Keine
Messbefehl, welcher Digitaleingang Kombination 3 (DI2=1, DI1=1) zugeordnet ist..
• Stop
• Level
• Up
• Bottom level
• Upper I/F level
• Lower I/F level
• Upper density
• Middle density
• Lower density
• Repeatability
• Water dip
• Release overtension
• Tank profile
• Interface profile
• Manual profile
• Level standby
Upper I/F level
Lesezugriff
Schreibzugriff
Bediener
Instandhalter
Bedienmenü
229