Ec Type-Examination Certificate, Directive 94/9/Ec And Coc Certificates Of Conformity (Iec); Description Of Measuring System - Endress+Hauser Proline Promass 40 Bedienungs- Und Sicherheitshinweise

Proline Promass 40
Installation instructions
(continued)
EC type-examination
certificate,
directive 94/9/EC
and COC certificates of
conformity (IEC)
Description of measuring
system
Endress+Hauser
Turning the transmitter housing
1. Unscrew the grub screw.
2. Rotate the transmitter housing cautiously clockwise until the end stop (end of the thread).
3. Rotate the transmitter housing counter-clockwise (max. 360°) in the wanted position.
4. Tighten the grub screw again.
1
Fig. 1: Turning the transmitter housing
EC type-examination certificate, directive 94/9/EC
The system meets the fundamental health and safety requirements for the design and construction of devices
and protective systems intended for use in potentially explosive atmospheres in accordance with appendix II
of directive 94/9/EC.
Certification number: DMT 00 ATEX E 074 X
COC certificates of conformity (IEC)
By affixing the certification number the conformity with the following standards
(depending on the device version) is certificated:
• IEC 60079-0 : 2004
• IEC 60079-1 : 2003
• IEC 60079-7 : 2006
Certification number: IECEx BVS 06.0019 X
Inspection body
DEKRA EXAM GmbH (previously Deutsche Montan Technologie GmbH, institute for the safety of electrical
apparatus, mining test facility)
Identification
see Page 19
The measuring system consists of transmitters and sensors:
• Compact version: transmitters and sensors form a mechanical unit.
ATEX II2GD; IECEx Zone 1, Zone 21
2
3
r
• IEC 60079-11 : 2006
• IEC 61241-0 : 2004
• IEC 61241-1 : 2004
max. 360°
Nicht-eigensichere
Stromkreise durch
4
IP40-Abdeckung geschützt
Non-intrinsically safe
circuits Ip40 protected
Boucles de courant
sans sécurité intrinsèque
protégées par Ip40
0
A0006944
17