Change Filter Element - Separ Filter LKF-Automotive Originalbetriebsanleitung

LKF-Automotive
Maintenance

9.6 Change filter element

D10107-EN-R05
The filter element must be changed regularly, at the latest, 12 months after operational
start-up.
Whether an earlier change is required can be determined unambiguously only with a dif-
ferential pressure measurement between medium supply flow and medium run-off. If such
measuring equipment is not available, the condition of the filter element must be tested
regularly by a visual check. We recommend to change the filter element in case of soiling
which is obviously identifiable from externally and to also clean the container in this case.
With the change of the filter element, basically new seals must be used and the sealing
surfaces in the filter body, as well as in the container, cleaned free of residue. An already
used filter element may not be used again.
1 Stop machine or block supply
pipe.
4 Discharge filter.
7 Clean container.
10 Complete filter element.
13 Tighten the loosened plug or
the loosened pipe connection
with the specified torque.
2 Release the drain valve and open
it about half a turn.
5 Disassemble container.
8 Complete container.
11 Insert the completed filter ele-
ment into the container.
14 Evacuate the air from filter, then
start machine or unblock supply
pipe.
3 Loosen one sealing plug or one
pipe connection and open it by
about one turn.
6 Remove used filter element from
the container and dispose of in
an environmentally friendly
manner.
9 Unpack new filter element and
O-rings.
12 Assemble container.
31/35