Operation - cecotec Ready Warm 4000 Slim Fold Bedienungsanleitung

ENGLISH

5. OPERATION

The heater can be adjusted to 3 different positions:
• : Low
• : Medium
• : High
LIGHTING:
WARNING: during operation, the pilot light should be steady. in case it flashes or the flame is
yellow, the heater should be checked to make sure it is in good conditions.
1. Open the valve on the heater cylinder 1 and ½ turns.
2. Press down the gas-control knob and turn it clockwise to the 1-Low position. Hold for 10
seconds.
3. While pressing down the gas-control knob, press the ignitor once or twice until the pilot
light (at the bottom of the burner) turns on.
4. Keep pressing down the gas-control knob for another 10-15 seconds.
5. Let go the gas-control knob. If the pilot flame fails to light up, repeat the process again.
WARNING: when lighting a new heater for the first time, it might be necessary to hold the gas-
control knob down for longer time in order to allow gas to flow to the pilot.
6. When the heater is turned on and the gas-control knob is set at 1-Low, turn it clockwise to
2-Medium in order to light the second panel and 3-High to light the third one.
7. Once you have finished using the heater, turn the gas-control knob anticlockwise to the
OFF position and close the cylinder valve by turning it clockwise.
WARNING: the heater can only be turned off by closing the cylinder valve. It cannot be turned
off by the control knob.
CHANGING THE CYLINDER:
Turn the cylinder valve fully clockwise and allow the heater to completely cool down before
removing or replacing the cylinder.
WARNING: do not attempt to remove the regulator while the heater is still operating.
SAFETY SYSTEM
The device includes several safety features that will shut down the heater when operation is
not safe. The device will automatically turn off in the following cases:
16 READY WARM 4000 SLIM FOLD