Safety Instructions; Product Assembly - cecotec Ready Warm 4000 Slim Fold Bedienungsanleitung

2. SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance. Keep this instruction manual
for future reference or new users.
• This appliance is intended for household use only. Do not use for industrial or commercial
purposes.
• Do not use the appliance if it does not operate properly.
• Maintenance and repairs must be carried out by a qualified technician only. The product
must be checked annually for safe operation and fault detection.
• Do not operate the product near walls, curtains or furniture and do not place objects on it
during operation. Place the device always facing towards the centre of the room.
• Always operate the appliance in well-ventilated room. Do not operate in bathrooms,
caravans, boats or rooms smaller than 20 m
• Do not move the appliance while it is operating.
• Carry out a leak test before operating the product for the first time and after connecting
the gas cylinder each time.
• Never use a naked flame to test for possible leaks.
• Close the gas-cylinder valve while the product is not operating.
• The appliance is not intended to be used by children under the age of 8. It can be used by
children over the age of 8, as long as they are given continuous supervision.
• This appliance can be used by children aged 8 and above, and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, as long as
they have been given supervision or instruction concerning the use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the appliance.
• Supervise young children to make sure that they do not play with the appliance. Close
supervision is necessary when the appliance is being used by or near children.

3. PRODUCT ASSEMBLY

Take the product out of the box, remove all packaging materials and follow the steps below:
1. Open the left and right panels towards the outside, at a 10-degree angle and the bottom
one towards the inside.
2. Place the device in an upright position and place the left, right and bottom panel at a
90-degree angle.
3. Take the 3 panels to the correct position and fix them properly.
.
2
READY WARM 4000 SLIM FOLD
ENGLISH
13