Operation - cecotec Ready Warm 8700 Power Steel Bedienungsanleitung

• Fix the adjusting brackets to the sliding brackets using a screw, a spring washer and a nut.
• Slide the adjusting brackets into the devices rails until they align with the holes of the
device and fix them into position with the wing nut to avoid them from moving.
• Drill 4 45-mm holes in the wall, 800 mm away from each other to fix the wall brackets on
and insert the expansion screws. Mount the wall brackets as shown in the diagram and
fix securely.
• In order to mount the appliance onto the wall brackets, align both brackets together and
fasten using a combination of screw, flat washer, spring washer and nut through the
centre holes.
• Once both brackets are aligned and fixed together into the desired position, the side holes
can be used to select and fix the angle of operation.
FLAT WASHER
SPRING WASHER
NUT
SCREW + FLAT WASHER +
SPRING WASHER + NUT
WING NUT
READY WARM 8700 POWER STEEL
ENGLISH
EXPANSION SCREWS
35