Operation - cecotec Ready Warm 8200 Power Quartz Smart Bedienungsanleitung

• Insert the thinner, adjustable section stand (10) into the top section of the stand (9) at
your desired height and screw it
firmly together.
• Unscrew the mounting screw
almost completely out of the
mounting bracket. Place the head
of the device over the top of the
adjustable stand section in such a
way that the screw falls precisely
into the hole in the stand. Tighten
the screw firmly making sure
that it does not protrude the thin
adjustable section of the stand. The thin section of the stand can rotate 360º, enabling
the head of the appliance to rotate in any direction. The electrical cable can be secured to
the cable holder on the stand.
This device must be placed at a distance of at least 1 m away from the nearest wall. The heater
head must be at least 30 cm away from ceilings and 1.80 m above the ground. The device must
be placed firmly on an even and completely horizontal surface.

5. OPERATION

Appliance operation
• Point the top of the appliance in the desired direction.
• Connect the device to a power supply.
• Press the on/off switch to switch the device on. (4)
• The heating power level can also be selected from the power button (2) on the remote.
One click will activate 1000 Watts, two clicks 2000 Watts.
• The timer function can also be programmed from the timer button (3). Note: The device
can be programmed up to a maximum of 7 hours.
Remote control operation
• Press button (11) to turn the device on and off.
• Press button (12) to set operating time.
• Press button (13) solo set the desired power: 1000/2000 W.
READY WARM 8200 POWER QUARTZ SMART
ENGLISH
35