Before Use; Product Assembly; Operation - cecotec Ready Warm 5300 Power Box Ceramic Bedienungsanleitung

ENGLISH

3. BEFORE USE

• Take the product out of the box.
• Remove all packaging materials. Keep the original box.
• Make sure all the components are included and in good conditions, otherwise,
contact immediately the official Technical Support Service of Cecotec.
• Make sure that there are no electric cables or other installations (for example
water pipes) near the drill holes.
• Make sure that the appliance is securely and horizontally fitted to the wall.

4. PRODUCT ASSEMBLY

• Drill 2 holes on the wall, at 2 m above the ground and 25 cm from the nearest corner.
• Make sure the drill holes match the expanding pipes' diameter.
• Insert the expanding pipes in the drill holes.
• Fix 2 screws to the expanding pipes in such way that they protrude 10 mm.
• Hang the heater from the screws.
READY WARM 5300 POWER BOX CERAMIC

5. OPERATION

Setting time
• Turn the device on and press the
control panel will light on, the display will show "00:00" and the "Mo" light indicator will
turn on. Then, use the and buttons to set the desired day.
• Hour: Press the button once, the LED display will show "00" blinking. Then, use the
and buttons to set the desired hour, from 01 (1 h) to 00 (24 h).
• Minute: Press the
button once again, the LED display will show "00" blinking. Then, use
the and buttons to set the desired minutes, from 01 (1 min) to 59 (59 min).
• Week: Press the
button, the "Mo" light will blink. Then, use the
set the desired week, from Monday (Mo) to Sunday (Su).
Note: When the button is pressed, the digits on the display will blink for 5 seconds.
If no buttons are pressed for 5 seconds, the device will switch to standby mode.
General operation
• Turn the device on by pressing the
blowing cold air.
• Press the button on the remote control for the unit to blow warm air. The
light on.
• Press the button again on the remote control for the unit to blow hot air. The
will light on.
• Press the button on the remote control a third time for the unit to maintain room
temperature.
24-hour timer function
• Turn the device on and select the desired operating mode through the remote
control following the instruction above.
• Press the "24H" button and set the timer up to 24 hours. To do so, hold down the
"24H" button until the desired time is displayed 00-24 (00=off, 01=1 hour, 02=2
hours... 24=24 hours etc.). The
Note: If 00 is set, the timer function will be off and the
Thermostat
• Turn the device on and select the desired operating mode through the remote
control following the instruction above.
ENGLISH
button on the remote control. The indicator on the
and buttons to
button on the remote control. The unit will start
icon will light on.
icon will not light on.
READY WARM 5300 POWER BOX CERAMIC
icon will
icon