Before Use; Operation - cecotec Ready Warm 6050 Ceramic Pisa Bedienungsanleitung

3. BEFORE USE

• Take the product out of the box and remove any packaging materials.
• Check for any visible damage, if any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
• Place the heater on a flat and stable surface.
• Set the power-level knob at "0" and plug the product's cord into an earthed power supply.

4. OPERATION

1
POWER-LEVEL KNOB (1)
: low-power heating (1000 W).
: high-power heating (2000 W).
THERMOSTAT (2)
• MIN: lower room temperature.
• MAX: higher room temperature.
when the desired temperature has been reached, the heater will turn off automatically.
NOTE:
In order to increase the desired room temperature, turn the temperature knob clockwise.
FAN MODE
1. Turn the thermostat (2) clockwise.
2. Set the power-level knob to
3. The device will operate in fan mode, without heat.
.
2
READY WARM 6050 CERAMIC PISA
ENGLISH
11