Deck Layout; Jib Boom And Main Boom Setting - Reely Sail Force 920 Bedienungsanleitung

13. Deck layout

J2
J1
E1
The jib boom and main boom cordage should thread through the deck eyelets as follows:
Jib boom:
• J2 → J1 → E1 → E2 (fasten using "S" hook)
• J3 → J4 → E2 → E4 (fasten to the clip)

14. Jib boom and main boom setting

Prerequisites:
• Batteries are installed: See "16. Insert batteries" on page 41".
• Transmitter and receiver are bound: See "17. Transmitter and receiver binding" on page 42".
J1 J2
E1
1. Transmitter: put the sail control stick in the down position then switch the power ON.
Leave the control stick in the down position until you finish making adjustments.
2. Receiver: switch the power ON. The sail servos will pull the jib boom and main boom all the way in.
3. Jib boom adjust:
1
- Distance from jib boom to centerline: 25 - 30 mm. Slide J3 and J4 to make adjustments if needed.
2
- Distance from jib boom to mast: 10 mm. Slide J1 and J2 to make adjustments if needed.
4. Main boom adjust:
3
- Main boom should be on the centerline. Slide M2 and M3 to make adjustments if needed.
5. Power OFF: switch the receiver OFF and then transmitter OFF.
40
J5 J6
J3 J4
E2
1
2
J3 J4
E2
M1
E3
E4
Main boom:
• M3 → M2 → E3 → E4 (fasten to the clip)
M2 M3
E3
E4
M3 M4 M5
M2
3