Installing The Grill Cooking Components - Pit Boss Navigator PB1230 Montageanleitung

13. INSTALLING THE COOKING COMPONENTS
Parts Required:
1 x Flame Broiler Main Plate (#4)
1 x Flame Broiler Slider (#3)
Flame Broiler Adjusting Bar (#5)
1 x
Flame Broiler Adjusting Bar Handle (#6)
1 x
1 x Smoker Adjusting Bar (#13)
3 x Heat Tent (#7)
4 x Porcelain-Coated Casted-Iron Cooking Grids (#2)
Porcelain-Coated Upper Cooking Rack (#1)
2 x
Installation:
• Insert the Flame Broiler Main Plate into the main grill. Rest the Flame Broiler
Main Plate on the built-in ledge (on the inside right) of the Main Grill
that directs grease towards the grease bucket spout. Slide the entire piece to
the left side, and the two slots on the Flame Broiler Main Plate will fit into the
rounded ledge above the burn pot. It will sit slightly at a downward angle.
Note illustration 13A.
IMPORTANT: If the Main Plate is resting on the base of the Barrel, it is
installed incorrectly. Poor installation may result in damage to your Main
Grill Barrel.
• Place the Flame Broiler Slider on top of the Flame Broiler Main Plate covering
the slotted openings. Ensure the raised tab is on the left and the two pins
at the bottom of the Flame Broiler Slider place into the holes of the Flame
Broiler Main Plate. To Easily adjust for direct or indirect flame when cooking.
Both Flame Broiler parts are lightly coated with oil to avoid rusting when
shipped. Note illustration 13B.
NOTE: When the flame broiler slider is open, and direct flame is used while
cooking, do not leave the grill unattended for any period of time.
• Insert the Flame Broiler Adjusting Bar through the opening hole on the left
side of the Main Barrel. Add the Flame Broiler Adjusting Bar Handle on the
end outside the Barrel. Next, slide the notched end of the Adjusting Bar into
the locking tab on the Flame Broiler Slider, giving you adjustable access to the
Flame Broiler Slider on the Main Plate. Note illustration 13C.
• Screw in the Smoke Adjusting Bar and tighten it. Should slide from front to
back smoothly. Note illustration 13D.
• Place the three Heat Tents on the top of the burners. Place the Cooking Grids,
side-by-side, on the grid ledge inside the Main Grill. Place the Upper Cooking
Rack on the upper ledge inside the Main Grill. The Cooking Rack will lock into
place. Note illustration 13E.
NOTE: To maintain the searing and grilling performance of your cooking
grids, regular care and maintenance Is required. See Owner's Manual.
13A
4
13B
3
4
13C
B
A
5
B C
5
6
13D
13
13
13E
1
2
C
1
2
7
9