Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack after
removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then
review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage
is not covered under warranty. Contact your dealer or Pit Boss
FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws completely
until all screws for that step have been installed. Hardware combination involving a locking washer and washer should be
installed with the locking washer closest to the head of the screw.
1. ASSEMBLE THE GREASE TRAY SUPPORT
Parts Required:
2
x
Grease Tray Support A (#15)
2
x
Grease Tray Support B (#16)
4
x
Screw (#D)
Installation:
•
Mount Grease Tray Support A to Grease Tray Support B using four screws.
2. MOUNTING THE GREASE TRAY TO THE MAIN BARREL
Parts Required:
1
x
Main Barrel / Hopper Assembly (#11)
6
x
Screw (#A)
6
x
Washer (#B)
Locking Washer (#C)
6
x
1
x
Power Cord (#36)
1
x
Cable Clip (#35)
Installation:
•
Place a piece of cardboard on the floor to prevent scratching the unit. Lay the
Main Barrel on it's side, hopper end pointed upward on the cardboard.
•
Mount Grease Tray Support to the floor end of the Main Barrel using six
screws, locking washers and washers. Note Illustration 2A.
•
Please replace with the correct power cord for your country, if you find
the power cord does not match the plug you are using.
•
Place the cable clips on the correct power cord. Insert the power cord
into the grove at the bottom of the hopper. Secure the cable clip to
the bottom of the hopper with the previously installed screw. Note
Illustration 2B.
ASSEMBLY PREPARATION
Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/
®
ASSEMBLY INSTRUCTIONS
1
16
15
2A
11
2B
35
36
A
C
B
5
Werbung
Kapitel
Inhaltsverzeichnis
