Teufel MakStride Gebrauchsanweisung Seite 34

ES
FR
EN
MakStride
DE
Select the wedge according to the foot
size. If the heel is too soft, insert the
selected wedge into the heel. The wed-
ge has to be inserted completely, so its
tip touches both the heel spring and the
calf shank. To prevent it from becoming
loose during the fitting in the workshop,
attach the wedge to the calf shank, e.g.
with a piece of PVA adhesive tape.
Ask the user to test-walk the foot. If the
user feels the heel is too rigid (and/or
the relation of heel to forefoot lever too
imbalanced), remove the wedge, and cut
off no more than 1/3 of the wedge along
the cross direction of the thicker back of
the wedge.
Ask the user to test walk the foot
again. If required, again cut off no
more than 1/3 of the wedge in the
cross direction.
EN-14
User Manual
Caution! After the right length of
the wedge has been determined, it has
to be glued in place. The glue has to be
applied on the top side (towards the calf
shank) of the wedge, since gluing the
bottom side (heel spring) of the wed-
ge would result in noise emission. We
recommend only applying the glue along
the lateral edges of the top side of the
wedge, so it can be removed or replaced
at a later point in time if required.