Dräger Polytron 6100 EC WL Gebrauchsanweisung Seite 56

en |
Troubleshooting
Byte Bit Description
16 0 OUT_OF_SERVICE
1 INSTALLATION_CALIBRATION
2 FAULTS_SENSOR
3 FAULTS_ELECTRONICS
4 M: Maintenance required
5 O: Out of specification
6 C: Function Check
7 F: Failure
17 0 NO_SENSOR_ERROR
1 ERROR_CAPTURE_CURRENT
2 ERROR_SENSOR_LOCK
3 ERROR_SDS_CYCLIC_CHECK
4 PROGRAM_FLOW_ERROR
56 Instructions for use |
Dräger Polytron
Cause
Start sequence active.
Start sequence failed.
Calibration or bump test active.
Sensor not detected or defective.
For the activated sensor lock feature, a
sensor with a different part number was
inserted.
Serious device fault, various causes.
–
–
–
–
No sensor used.
Error in EC sensor.
Sensor lock feature enabled.
Error in EC sensor.
Error in electronics.
®
6100 EC WL, Dräger Polytron
Remedy
Wait for start sequence.
A Restart the device.
B Have the gas detector checked by Dräger-
Service.
Finish calibration or bump test.
A Check the sensor connection.
B Remove and reinstall the sensor.
C Change the sensor.
D Insert sensor with the correct part number.
A Restart the device.
B Reset device to factory settings.
C Update firmware.
D Have the gas detector checked by Dräger-
Service.
–
–
–
–
Use sensor.
Change the sensor.
A Insert sensor with the correct part number.
B Deactivate sensor lock feature.
Change the sensor.
A Restart the device.
B Reset the sensor to the factory settings.
®
Repeater WirelessHART
®