Fuses - AL-KO solo R13-72.5 HD Betriebsanleitung

Controls
Dri- Description
ving
direc-
tion
To move forward, press on the right
For- hand pedal (09/1). The more you
wards press on the pedal, the faster the ride-
on mower moves forward.
To move backward, press on the left
hand pedal (09/2). The more you
press on the pedal, the faster the ride-
on mower moves backward.
ADVICE
If mowing is to be carried out
while moving backwards, the
button for mowing while re-
versing (07/2) must have pre-
Re-
viously been actuated.
verse
If reversing without mowing,
there is no need to press the
button for mowing while rever-
sing (07/2).
Mowing in reverse:
see section "Button for mowing
while reversing".
Lever for adjustment of cutting height (02/1)
Use this lever to set the cutting height in the range
between 30 and 80 mm in 7 steps. When the lever
is in the highest position (A), the cutting height is
at the maximum. When the lever is in the lowest
position (B), the cutting height is at the minimum.
To change the cutting height, proceed as follows:
1. Press the lever outwards.
2. Move the lever up or down to the desired po-
sition.
3. Press the lever inwards to engage it in the
selected position.
ADVICE
Always engage the lever in the chosen
position so that the mower mechanism is
fixed, and does not move unexpectedly.
To lock and unlock the hydrostatic transmis-
sion (01/1).
This lever is located next to the left rear wheel,
and has two positions indicated by a label:
Item Description
A Lever is pushed in. The hydrostatic trans-
mission is in operation, i.e. ready to drive
and mow.
B Lever is pulled out. The hydrostatic trans-
mission is not in operation. The ride-on
mower can be pushed with the engine
switched off.
CAUTION!
Risk of material damage.
If the lever is actuated while the en-
gine is running, the hydrostatic trans-
mission may be damaged, and the
ride-on mower may roll away.
Actuate the lever for the hydrostatic
transmission only when the engine is
stopped and the parking brake is app-
lied.

FUSES

The fuses are located at the front of the ride-on
mower, underneath the front access flap (10/1).
The fuses are as follows:
Fuse Description
F1 Strength: 5 A. Fuse to protect the gene-
(10/2) ral power circuits and the power circuits
of the electronic control card. If this fuse
blows, the engine stops and the control
light on the dashboard goes out.
F2 Strength: 15 A. Fuse to protect the char-
(10/3) ging circuit. If this fuse blows, the charge
of the battery falls gradually, and there
are problems starting.
F3 Strength: 100 A. Fuse to protect the star-
(10/4) ter. If this fuse blows, the starter no lon-
ger works.
These are flat fuses for motor vehicles. Test and
replace the fuses as follows:
1. Switch off the ride-on mower and remove the
ignition key.
2. Open the front access flap.
3. Pull out a fuse.
4. Check whether the fuse has burnt out.
5. If the fuse has burnt out: Replace it with a fuse
of the same strength, i.e. 5 A, 15 A, or 100 A.
6. If the fuse is not burnt out: Reinsert it.
41