Amp Replacement; Cleaning The Fixutre; Cleaning The Optics; Lubrication Of Rotating Gobos - JB-Lighting Varyscan P3 Handbuch

Inhaltsverzeichnis

Verfügbare Sprachen

5.2 Lamp replacement

see chapter 2.1

5.3 Cleaning the fixture

WARNING: Disconnect fixture from mains, and allow

To ensure a long and satisfying performance of the fixture, check function of the

VS P3 fans in the head and in the base from time to time. Most important: make

sure that there is no dust or fluff covering the air inlets.

To clean the fixture open lid of the head and the baseplate. Use a brush and a

vacuum cleaner to remove dust and fluff. Don´t damage or bend any parts.

Incompetend performace of the maintenance will invalidate the warranty claims.

Consult qualified service personnel.

WARNING: Disconnect fixture from mains, and allow

For a maximum light output the optical system has to be cleaned from time to time.

Loosen the screws holding the top cover of the head and remove the plastic lids of

both sides of the head.

Remove lamp before cleaning the optical parts of the fixture.

Use a soft cloth and gently whipe reflector, lenses and colour filters. You also may

use a pair of tweezers and a regular glass cleaner.

WARNING: Disconnect fixture from mains, and allow

Once or twice a year the rotating gobos have to be lubricated with JB-lighting

special oil. Do not use any other lubricant, as it might not stand the heat and

cause serious damage.

To lubricate the gobos turn the tooth gears by hand and put 4 to 6 drops of oil

between the brass gear wheel and the brass plate.

To update the fixture via PC/notebook, a Upgrade-dongle (USB/DMX converter) with the

fitting software is required. The update will be run with connecting the dongle to the 5 pin

DMX In from the Varyscan P3. Please ask your distributor to support you in that way.

hot lamp to cool down for at least 30 minutes!

Inhaltsverzeichnis