JB-Lighting Varyscan P3 Handbuch Seite 25

Reset DMX values of a step:
To reset the DMX values of a step proceed as follows:
Press key "Menu" one time. Then press 5 times key "+" -
will be shown on the display.
Confirm by pressing key "Enter".
Recall the desired step by means of the keys "+" and "-", confirm the selection
by pressing key "Enter".
Select function
After selecting the function press key "Enter".
Confirm selection by pressing key "Enter" again.
The DMX values of the selected step will be set to zero.
Store cues from a DMX board:
Select the Standalone menu:
Press key "Menu" first and then press key "+" five times.
STANDALONE STEPS
Confirm selection by pressing key "Enter".
Then press key "+" one time to enter capture function.
displayed.
Press "Enter" to enable the fixture to receive DMX data from a connected
DMX board. The display will show
"Enter" again. The display will show:
To insert a new step press key "+". The display will show:
Press "Enter" to confirm and the display will show:
To continue programming press key "-" one time and find:
shown on the display.
Press "Enter" to enable fixture to receive DMX data, and see confirmation
DMX CAPTURE
Repeat the process of storing data on the fixture by pressing "Enter" again.
(Press "Enter" first time:
CAPT DMX X / X)
To continue, insert a new step and repeat process.
26
STEP NR. 1/X
RESET STEP by means of the keys "+" and "-".
will be displayed.
DMX CAPTURE.
on the display.
START CAPTURE
will be displayed.
SURE? will be displayed.
CAPT DMX 1/ 1
To store data press
CAPT DMX 1/1
INSERT 2/2.
; Press "Enter" second time:
STANDALONE STEPS
will be
SURE?
CAPT DMX 2/2