Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Arrangement of the LED groups 1-19
The Pan/Tilt values are at 127/60. The display of the fixture is looking to the right side.
3.0 Important information
3.1 Color mixing
The Sparx7 features a color wheel emulation, main RGBW, pattern RGBW, glow RGBW and CTC
channel. The color wheel emulation has priority. Only if the color wheel emulation is set to DMX
value 000-001 it is possible to operate the RGBW channels. The glow RGBW is used for glow ef-
fects and can overlay the other colors. The CTC channel can be combined with both the RGBW
channels and the color wheel emulation. If the effect channels 9-13 are in use, the main RGBW
is used as background color and the pattern RGBW is used as foreground color (pattern color).
If color wheel emulation is active (DMX value > 001) the main RGBW is still used as background
color but the the effects ( foreground - pattern) are working with the color wheel emulation. Pat-
tern RGBW has no function in this juncture.
3.2 Control channel
The control channel (channel 5) offers additional control over the RGB-channels.
DMX 000-007: no white balance active.
DMX 008-015: basic adjustment on the RGB channels. So it's possible to have always the same
white from different production series (factory adjustment). Marginal reduced intensity of the
RGBW strings.
DMX 016-023: White balance, reduced intensity in blue, possible reduction in intensity of green
and red. If fixtures are set to this DMX value the white of color wheel emulation (color 0) and RGB
color mixing is the same.
DMX 024-031: White balance same to DMX 016-023, plus the RGBW curves are working in lin-
ear mode so it is possible to use the color picker function of various lighting control desks.
These areas are repeated 5 times to adapt the response of the Sparx7 to lighting consoles from
different manufacturers. The response runs from fast (mode 1) to slow (mode 5).
3.3 User notes
Control channel 5
Some lighting desks have a delay during DMX refreshing and DMX values get missed during a
fade out or using the fader. That means the Sparx7 with his fast reaction time rate this happen
as a shutter and shows flickering in the beam. To avoid this you can select 5 different operating
modes. Depending on the mode, the reaction time of the Sparx7 gets lower.
- 38 -
19
8
18
9
2
10
7
3
17
1
11
16
6
4
5
15
12
14
13
Werbung
Inhaltsverzeichnis
