Prepare For Use; Operation; User Interface Description - Nilfisk Liberty SC50 Gebrauchsanleitung

A - ENGLISH

PREPARE FOR USE

Before each use conduct a walk-around inspection to verify that the housing is intact.

OPERATION

A. Manual mode:
Manual cleaning with UVGI accessory selected will always turn UVGI on when one-touch scrub button is pressed. User can turn it off manually
using the Up/Down menu key. Be aware that the UVGI needs warm-up and cool-down time up to 30 seconds to preserve bulb life.
B. Autonomous Recording:
Recording plans with UVGI is not needed in order to be able to use existing saved plans. There is nothing to be done differently.
C. Autonomous Playback:
Autonomous playback follows the user option "Scrub with UVGI".
To playback a plan with UV, select this option to be "Yes".
To playback a plan without using UV cleaning, set the option to "No"
During playback of a recorded plan the two "AUTONOMOUS CLEANING" screens shown below will toggle.
AUTONOMOUS CLEANING
\ stop

USER INTERFACE DESCRIPTION

There is a visual indication of the UVGI module status on the right side. A UV icon will show if the UVGI unit is OK and operational. In manual
mode, user can turn UVGI on/off using Up/Down arrows. UVGI module status will be indicated under the UV icon on the right.
A - 6
INSTRUCTIONS FOR USE
MANUAL CLEANING P 1 fL
Ö Ø Ó Ò
ON ON
turn UV off
03:29
d
00:47
MANUAL CLEANING P 1 fL
Ö Ø Ó Ò
ON ON
turn UV off
Nil sk Liberty SC50 UVGI - 56091255
F
03:29
ON OFF
WAIT
AUTONOMOUS CLEANING 03:29 P 1 fL
Ö Ø Ó Ò
ON ON
\ stop
F
03:29
ON OFF
ON
F
ON OFF
ON
7/2021