Wiring Diagram With Electrical Filter Shaker; Use; Battery Check/Setting On A New Machine - Nilfisk SW 850S B Betriebsanleitung

WIRING DIAGRAM WITH ELECTRICAL FILTER SHAKER

-
BATTERIES 12V
-
BK

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay careful attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if they are damaged.

BATTERY CHECK/SETTING ON A NEW MACHINE

The machine requires one 12 V battery, or two 6 V batteries connected according to the diagram (40).
NOTE
If the machine is equipped with electronic battery charger (34), this must be connected to the batteries to allow the
machine to operate.
The machine can be supplied in one of the following confi gurations:
a) WET or GEL batteries already installed on the machine
b) WET batteries installed on the machine but without electrolyte
c) Without batteries
SW2
SW1
C2
WH
RD
RD C1 RD ES1
F1
RD
M2
BK
M1
BK
C1
SW 850S B
SW3
BN
OG BK
R1
OG
OG
YE
BU
GY
F2
GY
RD
BK
BK
146 0789 000(4)2007-03 A
USER MANUAL
F3
RD BK
M3
EB1
V- Out V+
Gel Pb
ENGLISH
S311455
11