Fitting The Front Moulding (Only Available On Certain Models); Fitting The Backguard (Only Available On Certain Models) - steel ADAGIO Gebrauchsanweisung

Instructions for the installer
3.3

Fitting the front moulding (only available on certain models)

For some cooker models, a front moulding is available to complement its aesthetics.
Before turning the cooker over, we recommend removing all the parts that are not stably attached
to it, in particular the cooking hob grids and burners. To lighten the weight of the cooker, the
accessories inside the oven may also be removed, thereby preventing accidental damage during
the overturning operation.
To assemble, proceed as follows:
tilt the cooker backwards;
•
align the moulding A with the mounting position as shown in the illustration;
•
apply the moulding until it fits into the mounting position;
•
pull the moulding downward so that it hooks onto the 4 pins B (two on each side) present on
•
the cooker.
3.4

Fitting the backguard (only available on certain models)

Proceed as follows to install:
rest the backguard A on the back of the surface, making sure the holes are aligned.
•
tighten the 4 screws B using a Phillips screwdriver.
•
Any yellowing of the steel over time, which is completely natural, in no way alters its original
characteristics. It can be removed using specific steel cleaning products.
67