General Warnings; Replacing The Adjustable Feet - steel ADAGIO Gebrauchsanweisung

3.1
The following operations must be carried out by a qualified installing technician. The
installing technician is responsible for correctly installing the appliance according to
current safety standards. Before using the appliance, remove the protective plastic on the control
panel, stainless steel parts, etc...
This appliance shall be installed only by authorised personnel and in accordance with the
manufacturer's installation instructions, local gas fitting regulations, municipal building
codes, water supply regulations, electrical wiring regulations, AS 5601/AG 601 - Gas
Installations and any other statutory regulations. Before using the appliance, remove the
protective plastic on the control panel, stainless steel parts, etc...
The manufacturer declines any responsibility for damage incurred by persons, animals or
objects that is caused by not following the above guidelines (cfr. chapter "2. Warnings for
safety and use").
The technical data is indicated on the plate located on the back of the appliance. The adjustment
conditions are shown on a label applied to the packing and the appliance.
Do not use the oven door handle for lifting or handling, including while
unpacking the appliance.
3.2
The cooker comes with standard feet, already installed.
The standard feet allow you to adjust the height so that you can level the cooker to the floor; the
cooker becomes unstable if you unscrew them too much.
To raise the cooker, you should replace the standard feet with higher ones (supplied with some
models or ordered from your retailer) for an extra 3 cm.
Before turning the cooker over, we recommend removing all the parts that are not stably attached
to it, in particular the cooking hob grids and burners. To lighten the weight of the cooker, the
accessories inside the oven may also be removed, thereby preventing accidental damage during
the overturning operation.
Proceed in either of the following ways to
replace the feet:
A
B
Remove the feet from the packing and screw
them to the bottom of the cooker.
Make the final adjustment of the feet, to level
the cooker to the floor, after completing the
gas and electrical connections.
Should you need to drag the equipment, tighten the feet all the way and then adjust them after
placing it where expected.
66
Instructions for the installer

General warnings

Replacing the adjustable feet

Lifting the cooker off the floor.
Laying the cooker on its back.