In The Event Of Faults And Failures - steel ADAGIO Gebrauchsanweisung

7.10 In the event of faults and failures

If a defect is noticed, switch off the appliance and turn off the electrical supplying.
Do not attempt to use a faulty radiant element until it is repaired by the authorised Technical
Support Service.
Any repairs must be carried out exclusively by qualified personnel. Do not open the appliance
for any reason.
If the glass surface is damaged, switch off the appliance immediately to prevent the risk of
electric shocks and contact the Technical Support Service.
If a radiant element is faulty, the remaining elements can still be used normally.
To clear the error code from the displays, set all the knobs to "0" position and set new power values.
The following list includes the most frequent failures, the causes of which can be removed by the
user or via the Technical Support Service.
FAULT
The hob or the cooking
zones do not switch on.
The display shows the
adjacent symbol.
The display shows the
adjacent symbol.
The display shows the
adjacent code
alternated with
numbers or letters.
The hob or a cooking zone
switches off.
The cooling fan stays on
after the hob is switched off.
98
Instructions for the user
CAUSE
The appliance is not correctly connected to the
mains.
The hob lock function has been activated.
There is no pan on the cooking zone.
The pan is not suitable for magnetic induction
cooking.
The diameter of the base of the pan is too small
for the cooking zone.
The knob is not positioned correctly.
The safety device has triggered. The device
triggers when a cooking zone is left on by mistake.
An empty pan has overheated.
This is not a fault.
REMEDY
Reconnect the appliance to the mains.
Deactivate the lock by following the instructions in
section 7.9
Correctly position a suitable pan by following the
instructions in section 7.5
Replace the pan with a suitable one, as indicated in
section 7.5
Replace the pan with a suitable one, as indicated in
section 7.5
It is not necessary to call Customer Service; to
restore the radiant element, simply return the knob to
position "0" and reset the required power value.
Contact Customer Service and give the code shown
on the display.
Return the relative knob to "0" position.
Remove the empty pan from the cooking zone.
The fan stays on until the hob has cooled down. The
fan will switch off automatically.