steel ADAGIO Gebrauchsanweisung Seite 70

COOKER 5 BURNERS (1 OVEN)
COOKER 6 BURNERS (1 OVEN)
COOKER INDUCTION HOB (1 OVEN) (6 ELEMENTS)
COOKER 6 BURNERS (2 OVENS)
COOKER INDUCTION HOB (2 OVENS) (6 ELEMENTS)
3.5.3
To replace the electric cable, it is necessary to access the terminal board. It is located on the back
of the appliance as shown in the figure.
To replace the cable, proceed as follows:
•
•
•
•
•
•
70
Instructions for the installer
DIAGRAM "A"
MODEL
Replacing the electric cable
open the terminal board box;
unscrew the screw A that locks the cable;
loosen the screw contacts and replace the cable
with one of the same length that corresponds to the
specifications in the table in section "3.5.1 Electric
power cable section";
the "yellow-green" earth wire must be connected to
the terminal and must be approximately 20 mm
longer than the line cables;
the neutral "blue" wire must be connected to the
terminal marked with the letter N;
the line wire must be connected to the terminal
marked with the letter L.
CONNECTION TO THE TERMINAL BOARD
DIAGRAM "B"
POWER CURRENT
kW DRAW (amps)
2.9 12
2.9 12
10.1 42
3.9 16
11.1 42