Programming The Timer - steel ADAGIO Gebrauchsanweisung

Instructions for the user
USING AND PROGRAMMING THE DIGITAL CLOCK ON TOUCH SCREEN OVENS
The digital clock enables the oven to be set to automatically switch on and off.
This programmer works like a touch screen; rest the tip of the finger on the key for a few seconds
to activate it.
INITIAL POWER-ON AND SETTING THE TIME
When first powering on the appliance or following a power failure,
on the display. Touch the
(hold down the / keys to scroll rapidly).
To adjust the time under normal operating conditions, i.e. when the clock is already on, touch both
keys / simultaneously for at least two seconds and then set the time as described previously.
MANUAL USE
This function is for using the oven without any programming.
It is always possible to switch from a programmed function to "Manuale" (Manual) function, by
touching the "Mode" key; choose "Manuale" if no cooking programmes are to be used.

PROGRAMMING THE TIMER

This function activates an audible alarm after a preset time, without interfering with the
operation of the oven.
The digital clock can also be used as a timer:
• touch the "Mode" key for at least 2 seconds to enter the programming menu; the flashing
symbol will appear;
• use the / keys to set the required time and the display will show the time remaining.
The timer starts automatically and the symbol
an audible alarm sounds for 7 minutes and the symbol
• touch any key to stop the alarm or the
"Mode" key to stop the flashing and use the
will stop flashing. When the set time is reached,
"Mode" key to delete the programme.
DECREASE KEY
MODE KEY
INCREASE KEY
and the word AUTO flash
/
will flash;
keys to set the time
85