Jump Starting - Waeco PerfectCharge W2000 Bedienungsanleitung

W2000.book Seite 42 Montag, 5. November 2007 6:00 18
Using the battery charger
6.3

Jump starting

To prevent accidental short circuits when connecting between the
vehicle battery and vehicle parts, the terminals of the starter cable
are isolated.
Caution – danger of chemical burns!
d
Avoid coming into contact with acid residue from the vehicle
battery.
This is how to jump start a vehicle:
➤ Find a suitable location so that battery charger still remains
upright after the engine has started (vibrations).
Risk of injury
d
Stay away from moving engine parts at all times.
➤ Connect the battery charger (chapter "Connecting the battery
charger" on page 38).
➤ Set the switch (fig. 7 6, page 5) to the required voltage ("12 V"
or "24 V").
➤ Set the switch (fig. 7 4, page 5) to "Jump start".
➤ If starting is not possible immediately, charge up the battery in
advance.
➤ Start the engine for a maximum of four to five seconds.
Once the engine is running
➤ Disconnect the battery charger (chapter "Disconnecting the
battery charger" on page 43).
42
All manuals and user guides at all-guides.com
PerfectCharge W2000