Advice About Transportation; Unpacking; Installation; Connection Diagram - Gastrodomus EFM200 Bedienungsanleitung

In addition, proceed as follows:
• do not allow the coolant gas and oil in the compressor to disperse
into the environment
• dispose of or recover the various materials according to the
provisions established by the current laws in force in your Country
This symbol means that this product should not be treated as a household waste. To prevent potential negative
consequences for the environment and health, be sure this product is correctly disposed of and recycled.
For information on the disposal and recycling of this product, contact your Distributor or the Waste Treatment Service.
This appliance does not contain coolant that damages the ozone layer. This appliance contains fluorinated greenhouse
gases covered by the Kyoto Protocol. This product is hermetically sealed.
The Manufacturer shall not be liable for any damage to the environment, animals, persons or objects caused by
incorrect installation.
2 TECHNICAL DATA (Fig. 1)
The voltage and frequency are given on the data plate on the appliance. Refer to this data plate to check compliance.
Voltage (1), power (2), model (3), serial No. (4), Manufacturer (5).
The weighted equivalent continuous sound level A of this appliance is less than 70 dB (A). The measurements were made over an
entire production cycle, at a distance of 1 m from the surface of the appliance and at a height of 1.60 m from the floor.
The wiring diagram is stuck on the rear panel of the appliance.

3 ADVICE ABOUT TRANSPORTATION

The net weight and the weight including packaging of the appliance are given on the cover of this manual. Please refer to the
instructions on the packaging in order to correctly transport and lift the appliance.
To prevent the oil in the compressor from flowing back into the coolant circuit, always make sure that the appliance is kept upright
during transport, storage, and handling. Follow the instructions given on the packaging.

4 UNPACKING

The appliance must be installed by authorized personnel, in compliance with the current laws in force and the
Manufacturer's instructions.
Once you have removed the packaging according to the instructions on the box, MAKE SURE THAT THE APPLIANCE IS IN A
PERFECTLY GOOD CONDITION. IF IN DOUBT, DO NOT USE IT AND IMMEDIATELY CONTACT THE DEALER who sold it to
you.
All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must be removed and put out of the reach
of children, as they are potential sources of danger.
Rest the wooden pallet on the floor, unscrew the bolts (if any) anchoring the appliance to the pallet (Fig. 2), lift the appliance using
equipment fit to bear its weight, and separate it from the pallet.
NOTE FOR INSTALLER:
This operation must only be performed by professionally qualified and authorized personnel.
The appliances contain threaded holes for hooking eyebolts (Fig. 3).
To prevent damage to the appliance, the lifting bolts should be kept vertical during lifting.

5 INSTALLATION

5.1 CONNECTION DIAGRAM (Fig. 4)
6. electrical connection controlled by omnipolar circuit-breaker with residual current device
7. water tap(s)
8. water supply pipe for ice making
9. water supply pipe for water cooling (W)
10. ice-making water drainage pipe
11. cooling water drainage pipe (W)
E N
E N