Advice About Transportation; Unpacking; Installation; Connection Diagram - Gastrodomus ESM160 Bedienungsanleitung

Should you decide to scrap appliance, first disconnect the power
cable from the mains, and then cut the cable off.
In addition, proceed as follows:
• do not allow the coolant gas and oil in the compressor to disperse
into the environment
• dispose of or recover the various materials according to the
provisions established by the current laws in force in your Country
This symbol means that this product should not be treated as a household waste. To prevent potential negative
consequences for the environment and health, be sure this product is correctly disposed of and recycled.
For information on the disposal and recycling of this product, contact your Distributor or the Waste Treatment Service.
This appliance does not contain coolant that damages the ozone layer. It contains fluorinated greenhouse gases covered
by the Kyoto Protocol. This product is hermetically sealed.
The Manufacturer shall not be liable for any damage to the environment, animals, persons or objects caused by
incorrect installation.
2 TECHNICAL DATA (Fig. 1)
The voltage and frequency are given on the data plate on the appliance. Refer to this data plate to check compliance.
Voltage (1), power (2), model (3), serial No. (4), Manufacturer (5).
The weighted equivalent continuous sound level A of this appliance is less than 70 dB(A). The measurements were taken 1 metre
from the surface of the appliance and 1.60 metres above ground, during ice production.
The wiring diagram is stuck inside front panel or on the rear panel of the appliance.

3 ADVICE ABOUT TRANSPORTATION

The net weight and the weight including packaging of the appliance are given on the cover of this instruction manual. Please refer
to the instructions on the packaging in order to correctly transport and lift the appliance.
To prevent the oil in the compressor from flowing back into the coolant circuit, always make sure that the appliance is kept upright
during transport, storage, and handling. Follow the instructions given on the packaging.

4 UNPACKING

The appliance must be installed by authorized personnel, in compliance with the current laws in force and the
Manufacturer's instructions.
Once you have removed the packaging according to the instructions on the box, MAKE SURE THAT THE APPLIANCE IS IN A
PERFECTLY GOOD CONDITION. IF IN DOUBT, DO NOT USE IT AND IMMEDIATELY CONTACT THE DEALER who sold it to
you.
All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must be removed and put out of the reach
of children, as they are potential sources of danger.
With the pallet resting completely on the ground, lift the appliance with lifting gear suited to its weight and separate it from the
wooden pallet.
NOTE FOR INSTALLER:
This operation must only be performed by professionally qualified and authorized personnel.
The appliances contain threaded holes for hooking eyebolts (Fig. 2). To prevent damage to the appliance, the lifting bolts should
be kept vertical during lifting.

5 INSTALLATION

5.1 CONNECTION DIAGRAM (Fig. 3)
6. electrical connection controlled by omnipolar circuit-breaker with residual current device
7. water tap(s)
E N
E N