Gastrodomus COOKMATIC SPECIAL Bedienungsanleitung Seite 10

COOKMATIC SPECIAL COOKMATIC SPECIAL
- close the cover (06);
- check that the two plates (04 and 07) are coupled;
- screw (do not tighten) the upper plate (07) to the cover (05) with the 4 fixture wing nuts (09);
- screw (do not tighten) the lower plate (04) to the base surface with the 4 fixture wing nuts (09);
- check couplings;
- mount 2 spacers (10) one on each side of the lower plate (04) with the 2 screws (1+1);
- hook on the plate closure handle levers (08) onto the spacers (10) and check automatic centring;
- open and close the cover (with the upper plate mounted) and check that the movement is not hindered
in any way;
- completely tighten the 4+4 wing nuts on the two plates;
- open and close the cover again to check.
MACHINE POWER-UP
Before you power up the machine, make sure that the available mains voltage is equal to the
electric voltage value indicated on the machine plate.
Plug the electric lead, built into the back of the machine, into a power socket.
To power up, turn the master switch knob, on the back of the machine, to position "I".
When the machine is on, three small lines meaning that the machine is ready for programming appear
on the illuminated command keypad display, on the front of the machine (02).
- - -
PROGRAMMING
Press the "ON" key:
- the display shows the temperature of the plates, measured in centigrade (°C) and the plate heating
phase begins (the heating phase terminates at the end of production when the "OFF" key is pressed).
- a red LED comes on on the lower right-hand display showing that the baking plates are starting to
heat. The LED will remain lit until the set temperature is reached after which it will go out.
It will come on again when heating restarts.
SETTING WORKING TEMPERATURE
The temperature can be programmed from 0 °C to 250 °C.
- Press the "TEMP" key. On the display the previously set temperature value will appear, referring to
the last process carried out by the machine, and stored in memory.
If the machine is new, the temperature value is the one relating to the final inspection test carried out
in PAVONI- ITALIA
- the required working temperature is set using the "+" and "-" keys and is shown on the display;
- press the "SET" key to confirm and memorise the set working temperature.
10
+
ON
TEMP
OFF
CONTROL KEYPAD
SET
-
TIME
START