Installing The Child Seat In The Vehicle (Isofix + Support Leg) - Casualplay Q-RETRAKTOR FIX Gebrauchsanweisung

• Clip the karabiner of the Top Tether (on the adjuster side) into the ring
on the rear part of the backrest (fig.12), and connect the other end to the
vehicle anchor point. (fig.13).
NOTE: consult your vehicle instruction manual to locate the Top Tether ring.
• Tighten the Top Tether until the red tab on the tension adjuster disappears
(fig.14-15).
• Unfasten the harness buckle.
• Seat the child in the child car seat.
• Adjust the headrest.
• Extract the harness straps by pulling the top part while at the same time
pulling the clasps and passing the straps over the child's shoulders.
• Fasten the safety buckle by joining the two clasps and inserting them into
the buckle.
• The Retraktor fix harness is fitted with an automatic wind up system that
adjusts the straps to fit the child's body.
• Lastly, make sure that the harness fits the child's body correctly, and if
necessary, pull the abdominal belt a bit to eliminate any loose gaps.
NOTE: The Q-Retraktor Fix fix is fitted with an automatic wind up system,
the same as the vehicle seat belt, which will lock the harness straps in the
event of sharp braking or an accident.
TAKING THE CHILD CAR SEAT OUT OF THE VEHICLE (ISOFIX +
TOP TETHER)
• Unfasten the safety harness and take the child out of the car seat.
• Unfasten the top tether by loosening the adjuster (fig.16) and unhooking
both karabiners (fig.17).
• Release the two isofix connectors by pulling the front lever (coloured red)
(fig.18). They will click when released, and a red signal will appear on
both connectors (fig.19).
• Remove the child seat from the vehicle seat.
INSTALLING THE CHILD SEAT IN THE VEHICLE (ISOFIX +
SUPPORT LEG)
NOTE: The support leg is an optional accessory that is sold separately.
• Fit the inlet sockets. Consult the section explaining how to fit them if necessary.
21