Adjusting The Headrest; Installing The Child Seat In The Vehicle (Isofix + Top Tether) - Casualplay Q-RETRAKTOR FIX Gebrauchsanweisung

ADJUSTING THE HEADREST

• Use the knobs on the sides to adjust the height of the headrest as
required (fig.1).
• The headrest should be positioned so that the harness is at the height of
the child's shoulders or slightly above. (fig.2).
How to use the buckle
• To open the buckle, press the red button (fig.3).
• To fasten the buckle, put the two clasps together and insert them into the
buckle (fig.4).
ADJUSTING THE RECLINING POSITION
• The reclining position of the child seat can be adjusted using the button
found on the lower part of the seat (fig.5).
• Hold the button pressed down until reaching the required position, a click
will indicate the different reclining positions.
FITTING THE INLET SOCKETS
NOTE: If your vehicle already has these inlet sockets there is no need
to fit them.
• Place the inlet sockets in front of both isofix anchor points, which are
found between the seat and the backrest (fig.6).

INSTALLING THE CHILD SEAT IN THE VEHICLE (ISOFIX + TOP TETHER)

• Fit the inlet sockets. Consult the section explaining how to fit them if
necessary.
• Position the child seat on the vehicle seat facing forwards.
• Extract the isofix connectors using the front button. Pull the button and
turn it to the right (fig.7).
• Press the safety seat against the vehicle seat (fig.8) until both isofix
connectors are fastened into the seat anchor points. It will click when
correctly fastened (fig.9), and a green signal will appear on each
connector (fig.10).
• Adjust the inclination of the seat. To do this consult the section referring
to adjusting the reclining position.
• Using the central button, adjust the chassis of the safety seat until it
touches the backrest of the vehicle seat. Pull the button and turn it to the
left (fig.11).
20