Herunterladen Inhalt Inhalt Diese Seite drucken

Fitting The Hood - Casualplay Baby Zero Plus Anweisungen

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 51
The original equipment must not be altered.
After an accident the seat should be examined or replaced.
Protect all parts of the seat from possible damage caused by the fold down seat or door
of the vehicle.
In sunlight the inside of the vehicle can reach very high temperatures therefore it is
advisable to cover the seat, when it is not in use, to protect the child from any possible
burns.
The harness straps should never be twisted.
Always use the safety seat, even on short journeys and never leave the child unattended
inside the vehicle.
It is important that the child can be unfastened quickly in an emergency, therefore the
buckle must never be covered up. It is advisable to teach the child that he must never
play with the buckle.
Take the seat out of the car whenever it is not going to be used for a while.
Any luggage or other objects that may cause injury in the event of a collision should be
secured.
We guarantee the safety of the device when it is used by the original buyer, do not use
second hand safety products or seats.
It is important that the other passengers in the vehicle also wear their seat belts, because
in the event of an accident they could get flung about and injure the baby.
Do not use the seat without the upholstery or with other upholstery that is not the
original one.
Regularly check the buckle, harness and other elements that could become loose or
suffer from wear and tear over time.
Wash the upholstery and fabric parts following the indications on the care labels on
each part.
Clean the plastic parts with mild soap and warm water.
Make sure that the upholstery of the vehicle seat does not make it difficult to tighten the
seat belt or adjust the harness of the seat.
Remember that you are responsible for the child's safety.
Instructions for use

Fitting the hood

Place the hood on the Baby Zero Plus and insert the two ends into the guides (fig.1).
Lastly, fasten the Velcro on the hood to the rear part of the backrest.
19

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis