Adjusting The Headrest - Casualplay BICARE FIX Gebrauchsanweisung

Instructions for use

Adjusting the headrest

• The headrest has 8 positions, to suit the child's height.
• Lift the upholstery (fig.01), pull the red handle while adjusting the height of the headrest.
The height of the harness will also change along with the headrest.
WARNING: Make sure that the headrest is not halfway between two
positions, and that the harness is at the right height at the child's shoulders
(fig.02)
Adjusting the length of the support bar
• Press the support bar adjustment button, and adjust the length until it touches the floor
of the vehicle (fig.03).
• A green indicator will appear on the support bar when it is fitted correctly.
• Check that the support bar is locked into place and that it does not move upwards or
downwards.
NOTE: Check that the length of the support bar is not halfway between two
positions, and that it touches the floor.
Adjusting the ISOFIX connectors
• Gently pull the ISOFIX connector adjuster, found on the front of the Bi Care Fix base,
this will pull the connectors out of the base (fig.04).
• With the ISOFIX connectors pulled out as far as they will go, fasten the base to the
ISOFIX anchors on the vehicle seat (as a general rule they are situated between the
backrest and seat of the vehicle). They will click when fastened, and a green indicator
will appear on each of the ISOFIX connectors of the base (fig.05).
• To finish fitting the Bi Care Fix base to the vehicle seat, gently pull the ISOFIX connector
adjuster again, while pressing the Bi Care Fix base against the seat.
• When you want to release the Bi Care Fix base from the vehicle seat, press both of the
ISOFIX release buttons, found on the sides of the ISOFIX connectors of the Bi Care
Fix base (fig.06).
Adjusting the backrest reclining position
• The Bi Care Fix has 3 reclining positions. For the group 0+, only the reclining position
18