Instructions For Bathing - Sentiotec IKI Monolith Montage- Und Gebrauchsanweisung

Instructions for use for the user

19. Instructions for bathing

The heating time for the stones and the sauna room is about 60 minutes depen-
ding on the size of the room and its ventilation. Throwing water on the heater
increases temperature and humidity. The top of the pillar creates more heat,
while the sides create a gentler steam.
The temperature should be set by the temperature control in the control unit. A
recommended temperature for the bathing with this heater is 55–70 degrees.
Maintenance:
Due to large variation in temperature, the sauna stones disintegrate in use.
Pay attention especially to the gradual settling of the stones. Be sure that the
heating elements do not appear with time. The stones settle most rapidly within
two months of piling. Rearrange the stones at least once a year or even more
often if the sauna is in frequent use. At the same time, remove any pieces of
stones from the bottom of the heater and replace any disintegrated stones with
new ones. By also leaving free airflow and spacing between the saunastones,
the heating capability of the heater stays optimal, is faster and the risk of over-
heating is avoided.
CAUTION!
Risk of injury about hot steam and hot water.
The maximum volume of the ladle is 0.5 litres. If an excessive amount of
water is poured on the stones, only part of it will evaporate and the rest
may splash as boiling hot water on the bathers. Never throw water on
the stones when there are people near the heater, because hot steam
may burn their skin.
20. Disposal
● Dispose of packaging materials in accordance with the applicable
disposal regulations.
● Used devices contain reusable materials and hazardous sub-
stances. Do not dispose of your used device with household
waste, but do so in accordance with the locally applicable regu-
lations.
WORLD OF WELLNESS
p. 20/22