Sentiotec IKI Monolith Montage- Und Gebrauchsanweisung Seite 28

Instructions for installation and use
● Always use silicone cables that are heat-resistant up to 170 °C
to connect the heater.
● Only install one sauna heater in the cabin. The monolith sauna
heater must not be used together with other sauna heaters in
a sauna cabin.
● The roof and walls of the sauna cabin shall be manufactured
from low-resin, untreated or thermally treated woods, e.g. Nordic
spruce, hemlock, pine or fir, or from laminated wooden materials.
If laminated wooden materials are used, make sure that the adhe-
sive does not produce formaldehyde. If other materials apart from
wood are used in the sauna cabin, these materials must be heat
and corrosion-resistant and must not have any negative effects
on the health of the sauna users.
● Observe the specifications on the minimum height of the sauna
cabin in chapter 21 on page 21.
● Observe the specifications on volumes of the sauna cabin in
chapter 21 on page 21.
● Observe the specifications on ventilation of the sauna cabin in
chapter 13 on page 15.
● When positioning the sauna heater, observe the minimum safety
see chapter 11. and 12. Safety distances on page
distances
(
14)
● Also observe the immediate surroundings of the installation
location.
● For your own safety, consult your supplier in the event of problems
that are not explained to a large enough extent in the installation
instructions.
WORLD OF WELLNESS
p. 6/22