Sentiotec IKI Monolith Montage- Und Gebrauchsanweisung Seite 39

Installation instructions, only for experts
15. Requirements for water quality
Water property
Humus concentration
Iron concentration
Hardness: most impor-
tant substances are
manganese (Mn) and
lime, i.e. calsium (Ca)
Chlorinated water
Seawater
16. Trouble shooting
If the heater or sauna room does not heat up, check that:
1. The power is on.
2. The power switch (start button on the control panel) is on.
3. The temperature knob is set to a higher temperature than the temperature
in the sauna room.
4. The fuses are intact.
5. The temperature restrictor (overheat protector) has not switched off. If tem-
perature restrictor has gone off, the reason must be solved before using
heater again
6. Check the error message "E-number" from the control panel. The cause of
the defect can be checked from the control unit manufacturer's instructions.
7. The stones are piled correctly.
This installation and operation manual is given to the owner/user
of the heater after the installation.
WORLD OF WELLNESS
Effects
Color, taste,
precipitates
Color, smell, taste,
precipitates
Precipitates
Risk to health
Fast corrosion
Recommendation
<12 mg/l
<0,2 mg/l
Mn: <0,05 mg/l
Ca: <100 mg/l
Use is completely forbidden
Use is completely forbidden
p. 17/22
EN