Important Information For Your Safety; Use As Intended; Safety Information For The Installation Engineer - Sentiotec IKI Monolith Montage- Und Gebrauchsanweisung

Instructions for installation and use

2. Important information for your safety

The Monolith sauna heater is constructed in accordance with rec-
ognised safety rules and regulations. However, hazards can occur
during use. Therefore, adhere to the following safety information
and the specific warning notes in the individual chapters.

2.1. Use as intended

The Monolith sauna heater is intended solely for heating private
sauna cabins, in conjunction with a control device which does not
include remote operation functions.
If the Monolith sauna heater is used for public saunas or for saunas
that incorporate a stand-by mode setting for remote operation, the
door of the sauna room must be fitted with an interlock such that the
stand-by mode setting for remote operation is disabled, if the sauna
door is opened when the stand-by mode setting for remote operation
is set. The requirements of the European standard EN 60335-2-
53 must be observed, especcially point 19.1, 19.101 and 22.108.
Any use exceeding this scope is not considered as intended. Use
that is not considered as intended can lead to damage to the product,
to severe injuries or death.

2.2. Safety information for the installation engineer

● Installing and connecting the sauna heater may only be performed
when the power supply is disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● An all-pole disconnecting device with full cut-off must be fitted
on-site in accordance with overvoltage category III.
WORLD OF WELLNESS
p. 5/22
EN