Maintenance And Cleaning; Cleaning The Appliance; Cleaning The Condenser; Emptying Condensation - coldline W5T Bedienungs- Und Wartungsanleitungen

14.0 MAINTENCANCE AND CLEANING
Routine maintenance work can be carried out by non-specialized personnel, following the instructions given
below to the letter.
Before performing any maintenance or cleaning work, disconnect the ap p p p pliance from the power Before performing any maintenance or cleaning work, disconnect the a
Before performing any maintenance or cleaning work, disconnect the a Before performing any maintenance or cleaning work, disconnect the a
mains. . . . mains
mains mains

14.1 CLEANING THE APPLIANCE

You can wash the inside and outside using a sponge damp with lukewarm water and detergents with a non-
aggressive chemical formula. Once you have finished cleaning, dry with a soft, dry cloth. You are advised to
apply polishing products on outer surfaces only.
Do not wash the appliance with jets of water. Do not use scouring pastes or steel wool. . . . Do not wash the appliance with jets of water. Do not use scouring pastes or steel wool
Do not wash the appliance with jets of water. Do not use scouring pastes or steel wool Do not wash the appliance with jets of water. Do not use scouring pastes or steel wool

14.2 CLEANING THE CONDENSER

To keep the appliance working efficiently at all times, clean the condenser at regular intervals. To do this, use
a brush with soft bristles or a vacuum cleaner, being careful not to bend the aluminium fins.
The condenser features sharp edges. Wear protective gloves when clean n n n ing The condenser features sharp edges. Wear protective gloves when clea
The condenser features sharp edges. Wear protective gloves when clea The condenser features sharp edges. Wear protective gloves when clea

14.3 EMPTYING CONDENSATION

The appliance features a tray to catch water produced by defrosting. This tray must be emptied at regular
intervals.
The data herein refer to items currently being produced. The manufacturer reserves the right to The data herein refer to items currently being produced. The manufacturer reserves the right to The data herein refer to items currently being produced. The manufacturer reserves the right to The data herein refer to items currently being produced. The manufacturer reserves the right to
make changes at any time as the manufacturer shall see fit to improve products, advising thereof make changes at any time as the manufacturer shall see fit to improve products, advising thereof
make changes at any time as the manufacturer shall see fit to improve products, advising thereof make changes at any time as the manufacturer shall see fit to improve products, advising thereof
only with the reprinting of this manual. only with the reprinting of this manual. only with the reprinting of this manual. only with the reprinting of this manual.
In models with built- - - - in condenser In models with built In models with built In models with built in condenser in condenser: : : : in condenser
1. To get to the condenser, loosen 4 screws at the instrument panel's 4
corners with a screwdriver, without removing them completely.
2. Pull the instrument panel down by 2 cm until it is released from its
housing.
3. Tirare Pull the panel off from the front to disconnect it from the
cabinet.
4. Put the panel down, being careful not to pull the interface's
electrical cables taut.
5. Refit the instrument panel once you have finished cleaning.
Nei modelli con unità condensante remota: Nei modelli con unità condensante remota: Nei modelli con unità condensante remota: Nei modelli con unità condensante remota:
1. Remove grille protecting the condenser (where fitted).
2. Perform cleaning.
Emptying Emptying c c c c ondensation ondensation: : : :
Emptying Emptying ondensation ondensation
1. Pull the tray out from the front.
2. Empty the water in the tray.
3. Fit the tray back into its original position.
pliance from the power
pliance from the power pliance from the power
ing. . . .
ing ing
39