Installation; Introduction; Damage Check; Cleaning - coldline W5T Bedienungs- Und Wartungsanleitungen

3.0 INSTALLATION

3.1 INTRODUCTION

The appliance must be used solely for the purpose it was specifically designed for, i.e. for storing food within
the temperature range stated by the manufacturer. Understand that any other use shall be considered
improper.
The Manufacturer declines all responsibility in the event of improper use of the appli i i i ance. The Manufacturer declines all responsibility in the event of improper use of the appl
The Manufacturer declines all responsibility in the event of improper use of the appl The Manufacturer declines all responsibility in the event of improper use of the appl
Installation must be carried out by specialized technical personnel only. Installation must be carried out by specialized technical personnel only. Installation must be carried out by specialized technical personnel only. Installation must be carried out by specialized technical personnel only.

3.2 DAMAGE CHECK

Check all parts of the appliance for damage and that the standard-issue accessories inside are as expected.

3.3 CLEANING

Remove the PVC film covering the inside and outside of the appliance. Clean the compartment inside using a
sponge damp with lukewarm water.

3.4 WORKING CONDITIONS

Make sure the room in which the appliance is installed meets the following conditions:
• Room temperature in the range +5°C to +43°C.
• Positioning away from sources of heat and in a well ventilated area.

3.5 LEVELLING

Move the appliance into its final position and adjust the screw-type feet until you have the unit perfectly level.
Keep the unit at least 10 cm from the wall for a proper ventilation of the technical compartment

3.6 PUTTING INTO OPERATION

Before connecting to the power mains, make sure:
• Voltage and frequency are in conformity with the working conditions featured on the CE plate inside the
appliance: maximum tolerance is ±10% of the rated value.
• The power supply circuit meets regulations in force.
• The electrical system is fitted with a residual current circuit breaker (automatic cutout).
• Earthing is compulsory.
If the appliance is going to be switched off for a length of time, it is best to disconnect its power cord.
The manufacturer cannot be held responsible for damage or injury resulting from failure to earth The manufacturer cannot be held responsible for damage or injury resulting fr The manufacturer cannot be held responsible for damage or injury resulting fr The manufacturer cannot be held responsible for damage or injury resulting fr
the appliance or inefficient earthing thereof, incorrect installation, tampering, poor maintenance the appliance or inefficient earthing thereof, incorrect installation, tampering, poor maintenance
the appliance or inefficient earthing thereof, incorrect installation, tampering, poor maintenance the appliance or inefficient earthing thereof, incorrect installation, tampering, poor maintenance
and incompetent use, or resulting from failure to comply with electrical safety standards in force in the and incompetent use, or resulting from failure to comply with electrical safety standards in force in the and incompetent use, or resulting from failure to comply with electrical safety standards in force in the and incompetent use, or resulting from failure to comply with electrical safety standards in force in the
country where the appliance is country where the appliance is country where the appliance is country where the appliance is used. used. used. used.
ance.
ance. ance.
.
om failure to earth om failure to earth om failure to earth
25