Time-Based Blast Freezing - coldline W5T Bedienungs- Und Wartungsanleitungen

• If you press button
how long it took.
The holding stage must last only as long as strictly necessary.
•
8. To exit holding mode, press button
• The led button
The compressor stops 5 5 5 5 seconds after button
•
Important Important
Important Important
• When a hard hard blast chilling cycle is started, the compressor works non-stop until air temperature in the
hard hard
compartment reaches - - - - 35°C
preventing the formation of frost.
• The blast chilling cycle ends when the timer completes the countdown.
8.3 TIME -BASED BLAST FREEZING
The time-based blast freezing cycle is controlled by the timer.
Shortcut commands while in standby mode Shortcut commands while in standby mode Shortcut commands while in standby mode Shortcut commands while in standby mode
1
Blast freezing
Detailed commands sequence: : : : Detailed commands sequence
Detailed commands sequence Detailed commands sequence
1. Make sure the appliance is in standby
2. Press button to select the blast freezing cycle.
• The led button
• Display DY1 DY1 gives the setpoint of the air in the compartment (- - - - 38°C
DY1 DY1
• Display DY2 DY2 reads "--- DY2 DY2
3. Press button to select a time-based cycle.
4. Use buttons and
5. Press button to start the blast freezing cycle.
• The led button
The compressor only starts working 5 5 5 5 seconds after key
•
• DY1 DY1 gives room probe temperature, DY2 DY1 DY1
• If you press button
6. A buzzer sounds to advise that the blast chilling cycle has finished.
7. At the end of the cycle, holding mode starts and continues indefinitely at a holding temperature of - - - - 20
• The led button
• If you press button
how long it took.
The holding stage must last only as long as strictly necessary.
•
8. To exit holding mode, press button
• The led button
The compressor stops 5 5 5 5 seconds after button
•
Important Important
Important Important
• When a blast freezing cycle is started, the compressor works non-stop until air temperature in the
compartment reaches - - - - 38°C
• The blast freezing cycle ends when the timer completes the countdown.
during holding time, you can view the time of the cycle just completed to see
.
goes off.
35°C. After this, it can cycle on and off to keep a constant temperature of - - - - 2°C
35°C 35°C
2
standby mode (6.1
standby standby
comes on.
---". --- ---
to set the desired cycle time.
comes on.
DY2 the cycle time remaining. DY2 DY2
while the cycle is running, you can view the time elapsed since it started.
flashes.
during holding time, you can view the time of the cycle just completed to see
.
goes off.
38°C. After this, it can cycle on and off to keep this temperature constant.
38°C 38°C
is pressed (pump-down 6.4
Time-based cycle
6.1).
6.1 6.1
38°C).
38°C 38°C
is pressed (pump-down 6 6 6 6 .4 .4 .4 .4).
is pressed (pump-down 6.4
6.4). 6.4 6.4
3
Start
6.4). 6.4 6.4
2°C,
2°C 2°C
20°C 20 20 °C. °C °C
33