Haccp Electronic Recorder (Optional); Switching On/Off; Operating Tips And Warning - coldline W5T Bedienungs- Und Wartungsanleitungen

Detailed commands sequence: Detailed commands sequence: Detailed commands sequence: Detailed commands sequence:
1. Make sure the appliance is in standby
2. Press button to call up an existing program.
• DY1 DY1 reads "P P P P 1 1 1 1 ".
DY1 DY1
3. Use buttons and
4. Press button to start the blast chilling/blast freezing cycle.

10.0 HACCP ELECTRONIC RECORDER (optional)

The electronic recorder is connected directly to the main control panel. It is used to record and produce a
paper printout of temperature and time data relating to the blast chilling and blast freezing cycles.
Maximum roll dimensions: : : : carta termica 58×Ø30 mm. Maximum roll dimensions Maximum roll dimensions Maximum roll dimensions
Print width: : : : 48 mm. Print width
Print width Print width
Number of dots per line: : : : 384. Number of dots per line
Number of dots per line Number of dots per line
Print density Print density: : : : 8 punti per mm. Print density Print density
Serial communication Serial communication: : : : RS485. Serial communication Serial communication

Switching on/off

Switching on/off Switching on/off Switching on/off
1. To switch the instrument on/off, press the
Manual paper feed Manual paper feed
Manual paper feed Manual paper feed
1. To feed the paper through manually, press the
Replacing paper Replacing paper Replacing paper Replacing paper
1. Switch the instrument off using the
• The led button
2. Open the front using the
3. Insert the roll of paper under the roller.
4. Hold the button down until the roller starts pulling the roll of paper.
5. Position the roll of paper in the relevant slot.
6. Close the front.
Print test Print test
Print test Print test
1. Switch off the instrument.
2. Press the button. . . .
3. Switch the instrument on.
11.0 OPERATING TIPS AND WARNINGS
Pre Pre Pre- - - - c c c c ooling Pre ooling ooling ooling
1
Soft blast chilling
Before blast chilling/blast freezing, it is best to pre-cool the compartment by running a temperature-based
soft cycle.
Avoid opening the doors while a blast chilling/blast freezing cycle is running.
standby mode (6.1 standby standby
to select the number of the available program.
button.
comes on.
button.
2
6.1). 6.1 6.1
button.
button.
Start
35