Programs; Creating A New Program; Calling Up An Existing Program - coldline W5T Bedienungs- Und Wartungsanleitungen

9.0 PROGRAMS

9.1 CREATING A NEW PROGRAM

If the product comes in small portions, the needle probe cannot be used and, moreover, cooling is quick and
will take much less than the maximum time. In such cases, it is a good idea to store a program with a
predefined time.
Using the programs feature, you can store up to 99
preset by the user for each.
Shortcut commands while in standby mode Shortcut commands while in standby mode
Shortcut commands while in standby mode Shortcut commands while in standby mode
1
Soft blast chilling
2
Time-based cycle
3
Select time
4
Save
Detailed commands sequence Detai Detai Detai led commands sequence led commands sequence: : : : led commands sequence
1. Make sure the appliance is in standby
2. Select a soft or hard blast chilling cycle or blast freezing cycle by pressing button
respectively.
3. Press button to select a time-based cycle.
4. Use buttons and
5. Hold button down for 5 5 5 5 seconds to enter the program menu.
• DY1 DY1 reads «P1 DY1 DY1 P1 P1 P1»; DY2
6. Use buttons and
• Led , or
7. Hold button down for 5 5 5 5 seconds to store cycle in the memory.

9.2 CALLING UP AN EXISTING PROGRAM

Shortcut commands while in standby mode Shortcut commands while in standby mode Shortcut commands while in standby mode Shortcut commands while in standby mode
1
Programs
2
Select program
3
Start
34
1
3
standby standby mode (6.1 standby
to set the desired cycle time.
DY2 shows the default DY2 DY2 default cycle time or «P1 default default
to select the number of the available program.
lights to indicate the kind of cycle the program refers to.
2
99 customized blast chilling/blast freezing cycles, with a time
99 99
Hard blast chilling
Select time
6.1). 6.1 6.1
P1» if it has already been saved before. P1 P1
Select program
1
Blast freezing
, or