Manual Defrosting; Temperature-Based Blast Chilling/Blast Freezing; Temperature-Based Soft Blast Chilling - coldline W5T Bedienungs- Und Wartungsanleitungen

- At the end of each blast chilling/blast freezing cycle.
- At 6-hour intervals during holding.
The purpose of the evaporator sensor is to produce the utmost efficiency and shorten defrosting times by
measuring the end-of-defrosting temperature.

6.8 MANUAL DEFROSTING

This mode should be used only when further defrosting is required in addition to that performed
automatically by the appliance.
Shortcut commands while in standby mode Shortcut commands while in standby mode
Shortcut commands while in standby mode Shortcut commands while in standby mode
Make sure the appliance is working (6.1
Hold button down for 5 5 5 5 seconds.
The led by the button comes on, and goes off when cycle ends.
The defrosting cycle stops automatically. How long it takes depends on how much frost there is on the
evaporator coil.
Once defrosting has finished, the appliance resumes normal operation.

7.0 TEMPERATURE-BASED BLAST CHILLING/BLAST FREEZING

7.1 TEMPERATURE-BASED SOFT BLAST CHILLING

The temperature-based soft
Shortcut comma Shortcut commands while in standby mode nds while in standby mode
Shortcut comma Shortcut comma nds while in standby mode nds while in standby mode
1
Soft blast chilling
Detailed commands sequence Detailed commands sequence: : : : Detailed commands sequence Detailed commands sequence
1. Make sure the appliance is in standby
2. Insert the needle probe in the product to be chilled (10.0
3. Press button to select the soft
• The led button
• Display DY1 DY1 gives the setpoint of the air in the compartment (- - - - 2°C
DY1 DY1
• Display DY2 DY2 DY2 reads "--- DY2
4. Press button to start the soft
• The led button
The compressor only starts working 5 5 5 5 seconds after key
•
• DY1 DY1 DY1 DY1 gives needle probe temperature, and DY2
minutes.
• If you press button
5. A buzzer sounds to advise that the blast chilling cycle has finished.
6. At the end of the cycle, holding mode starts and continues indefinitely at a holding temperature of +3°C
• The led button
• If you press button
how long it took.
The holding stage must last only as long as strictly necessary.
•
7. To exit holding mode, press button
• The led button
The compressor stops 5 5 5 5 seconds after button
•
6.1).
6.1 6.1
soft blast chilling cycle is controlled by the needle probe.
soft soft
2
standby mode (6.1 standby standby
soft soft blast chilling cycle. . . . soft
comes on.
---". --- ---
soft blast chilling cycle. soft soft
comes on.
while the cycle is running, you can view the time elapsed since it started.
flashes.
during holding time, you can view the time of the cycle just completed to see
.
goes off.
Start
6.1). 6.1 6.1
10.0). 10.0 10.0
2°C).
2°C 2°C
is pressed (pump-down 6.4
DY2 the cycle time remaining, counting down from 90 DY2 DY2
is pressed (pump-down 6.4
6.4). 6.4 6.4
90 90 90
+3°C. +3°C +3°C
6.4). 6.4 6.4
29