Original Accessories/Auxiliary Equipment; Before Use; Selecting A Sanding Sheet; Changing Sanding Sheets - Parkside PDS 290 C3 Originalbetriebsanleitung

Original accessories/auxiliary
equipment
■ Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury .

Before use

Selecting a sanding sheet

Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper .
■ Please note that you need to use appropriate
sandpapers with different grains for working
different materials .
Materials:
Wood (sanding sheets included in the delivery),
paints*, stone*
*Depending on the sanding sheet

Changing sanding sheets

The appliance has a Velcro sheet that enables fast
and simple changing of the sanding sheets .
WARNING!
► Always remove the plug from the mains power
socket before carrying out any work on the
appliance .
Attachment:
♦ You can attach the sanding sheet
sanding plate using the Velcro .
Make sure that the holes on the sanding sheet
match up with the holes on the sanding plate
Removal:
♦ Lift the sanding sheet
off the sanding plate
NOTE
► Before fitting a new sanding sheet
any dust and dirt from the sanding plate
PDS 290 C3
to the
on one side and pull it
to remove it (see fig . b) .
, remove
.
Turning the sanding plate in 60°
increments
WARNING!
► Always remove the plug from the mains
power socket before carrying out any
work on the appliance .
♦ Turn the sanding plate
in 60° increments until it clicks into the desired
position (see fig . C) .
Removal and surface:
The shape of the delta sander makes it easier to
sand in hard-to-reach places, corners and edges .
The material removal rate and surface quality are
determined by the grain strength of the sandpaper
and the set oscillation speed .
■ Please note that you need to use appropriate
sandpapers with different grains for working
different materials . Also adjust the speed
depending on the material .

Working procedures

■ Switch the appliance on before applying it to
the workpiece .
■ Apply minimal pressure when working .
■ Work at a constant speed .
■ Change the sanding sheets regularly .
■ Never sand different materials (such as wood
and then metal) using the same sanding sheet
Optimum sanding results can only be achieved
by using clean sanding sheets .
■ Clean the sanding sheet
while using a vacuum cleaner .
.
on the delta sander
every once in a
GB │ IE │ NI │ CY │
.
5 ■