Original Accessories/Auxiliary Equipment; Operation; Changing/Inserting The Tool/Collet Chuck; Whet Stone - Parkside PFBS 160 B2 Originalbetriebsanleitung

■ Always purchase the correct cell or battery for
an appliance .
■ Keep cells and batteries clean and dry .
■ If the terminals of the cells or batteries are
contaminated, clean them with a dry, clean
cloth .
■ Store the original instructions and information
about the products safely for future information
and reference purposes .
■ Cells and batteries may not be used in applica-
tions for which they are not designed .
■ Always remove batteries from appliances that
are not in use, if possible .
■ Do attempt to recharge non-rechargeable
batteries .
There is a risk of explosion!
Original accessories/auxiliary
equipment
■ Use only the accessories and auxiliary equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance .

Operation

Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Turn the tensioning nut
into place .
♦ Undo the tensioning nut
using the combination spanner
♦ Remove any attached tool .
♦ First push the intended tool through the
tensioning nut before inserting it into the
appropriate collet chuck
shaft .
♦ Press the spindle lock
♦ Push the collet chuck
and screw the tensioning nut
combination spanner
PFBS 160 B2
and hold it down .
until the lock clicks
from the thread
.
for the tool
and hold it down .
into the thread insert
tight with the
.
Using an accessory tool with a mandrel
♦ Use the screwdriver side of the combination
spanner to undo and tighten the screw on
the mandrels or
♦ Insert the respective mandrel
the appliance as described .
♦ Use the combination spanner
screw on the mandrel
♦ Insert the desired accessory tool between the
two washers on the screw .
♦ Use the combination spanner
screw on the mandrel

Whet stone

♦ Do not manually grind any edges with the whet
stone .

Fitting abrasive belts

♦ Push the abrasive belt
mandrel . Tighten the screw on the abrasive
belt mandrel in order to fix the abrasive belt
.

Fitting polishing attachments

♦ Screw the polishing attachment
of the mandrel for polishing attachments
Switching on and off/setting speed
range
CAUTION!
■ The rotation direction can be read off the
arrow engraved on the union nut
clockwise symbol) .
Switching on/setting the speed range
♦ Set the ON/OFF switch
♦ Set the infinitely variable speed control
a position between "1" and "MAX" .
Switching off
♦ Move the ON/OFF switch
"O" .
.
, or into
to undo the
or .
to tighten the
or .
onto the abrasive belt
onto the tip
.
(anti-
to the "I" position .
to
to the position
GB │ MT │ 63 ■