Input/Output (I/O) Setup - OHAUS Defender 5000-Serie Bedienungsanleitung

EN-50
Method 2
1. Use the alphanumerical keypad to key in the
desired averaging time.
2. Once the value keyed in is displayed in upper
left portion of the screen, press the Softkey
corresponding to the icon

4.5.3 Input/Output (I/O) Setup

The I/O's setup can be customized for various user preferences.
The I/O's setup is defined below (defaults in Bold).
Item
Enable
Discrete Input 1
Discrete Input 2
Discrete Output 1
Discrete Output 2
Discrete Output 3
Discrete Output 4
Note: The I/O's setup will only work when the I/O Option board has been installed. See the Accessory
list in section 9.2 for information. The option I/O board provides two isolated inputs and four dry-contact
normally open relay outputs which can be used for simple process weighing.
Press the button
Menu.
With the button corresponding to the icon
go down the list and highlight Application
Mode. Enter this sub-menu by pressing the
Softkey corresponding to the icon
In the Application Mode menu enter the sub-
menu Dynamic.
Select the list item and press the Softkey
corresponding to the icon
the setting as desired. After completion of I/O
Setup, press the Softkey corresponding to the
icon to return to the main application
screen.
.
Available Settings
On, Off
Off, Zero, Tare, Clear Tare, Print, Start, Reset
Off, Zero, Tare, Clear Tare, Print, Start, Reset
Off, Underload, Overload, Zero
Off, Underload, Overload, Zero
Off, Underload, Overload, Zero
Off, Underload, Overload, Zero
to enter the Main
.
icon to change
,
Defender 5000 Indicators