Defender 5000 Indicators; Transaction Counter; I/O Type; Reset - OHAUS Defender 5000-Serie Bedienungsanleitung

EN-24
On = sound

3.4.9 Transaction Counter

The transaction counter is a seven-digit counter that tracks the total transactions. When the value
reaches 9,999,999, the next transaction causes a roll-over to 0000001.
Off = the transaction counter will not increase.
On = the transaction counter will increase with the additional menu item Next Transaction
available.
NOTE: If the transaction counter is set to be ON, the count number will increase when press print
key.
3.4.9.1 Next Transaction
The value of the next transaction displays in the Next Transaction field.

3.4.10 I/O Type

Set the status of the relay output.
Open = The initial state of the relay output is normally open.
Closed = The initial state of the relay output is normally closed.

3.4.11 Reset

Reset the Setup menu to the factory defaults (except Range, Capacity and Graduation).
No = not reset.
Yes = reset.
NOTE: If the Security Switch is set to ON, the Capacity Unit, Range, Capacity, Graduation and Power
On Zero settings are not reset.

3.5 Readout Menu

Enter this menu to customize display functionality. Default settings are bold.
Read Out Options

Stability

0.5d, 1d, 2d, 5d

Zero Range

+/-2%, +/-100%
Filter Level Low, Medium, High
Auto Zero Track Off, 0.5d, 1d, 3d
Backlight Off, 1min, 2min, 5min,10min, Always On
Screensaver Off, 5min, 10min, 30min
Auto Off Off, 5min, 10min, 30min
1, 2, 3, 4, 5
Adjust Contrast
Reset
3.5.1 Stability
Set the amount the reading can vary before the stability symbol turns off.
0.5d = 0.5 scale division
1d = 1 scale division
2d = 2 scale divisions
5d = 5 scale divisions
3.5.2 Zero Range
Set the percentage of scale capacity that may be zeroed.
2%
100%
NOTE: The setting is forced and locked to 2% when the Security Switch is set to the locked position.

Defender 5000 Indicators